Insert Type 1

£6.86 - £59.44
Insert Type 1
£6.86 - £59.44
Ask a Question
Enter your details and we will get back to you

Product Information

Turning Insert

On small format machines, where mainly finishing cuts are applied, it is advisable to select the smallest possible corner radius. This helps to reduce vibration and therefore gives the best chance of obtaining excellent surface finishes at higher speeds. However, where rough or intermittent cuts are to be taken, remember that a bigger radius gives a stronger corner. Coupled with slower speeds, this is often the best solution.

Our general purposeTiN coated insert (NJ17) is designed to cut most materials, including steels, stainless steels, brass, bronze, aluminium and cast iron.

If you intend to machine only aluminium, copper and other soft, non-ferrous materials, then choose our Aluminium type insert. It has a polished top face, coupled with high top rake and very sharp edges to give improved surface finish and tool-life, whilst improving the resistance to built up edge. (Also works very well on plastics and wood.) Only available with 0.2mm and 0.4mm corner radius.

Our titanium carbide (cermet) inserts are especially suited to applications where a superior surface finish is required.They are designed to operate with shallow (finishing) cuts at light feedrates, and can run at low speeds if required. Only available with 0.2mm and 0.4mm corner radius.

MRRP on this product is £7.38, but we offer discounts depending on quantity, as shown below.